Induction Shrink Fitting For Inserts with IGBT Shrink fitting Heater
Objective: To heat an aluminum fuel pump housing measuring 8″ x 4 1/2″ x 3 1/2″ toĀ 3750F, allowing steel parts to be inserted. Presently the housings are heatedĀ for over one hour in a convection oven. The areas that are to have steel partsĀ inserted measure 1.5″ and 0.6875″ in diameter. In addition, the insertionĀ process lasts for a little over one minute, so 3750F should be maintained for a
period of time to complete the process.
Material: Aluminum Pump Housing measuring 8″ x 4 1/2″ x 3 1/2″
Steel insertion parts.
Temperature: 3750F
Application: By using the DW-HF-Ā 25, 25 kW output solid state induction powerĀ supply the following results were achieved.
– 3750F was reached in one (1) minute to allow for insertion.
–Ā 20 housings were successfully heated using a five (5) turn right angleĀ pancake coil.
Equipment: Ameritherm SP 25, 25 kW output solid state induction power supply includingĀ one (1) remote heat station containing four (4) capacitors totalling 1.0 Ī¼F, and Ā a five (5) turn right angle pancake coil made from 3/16″ copper tube.
Frequency: 80 kHz
