Induction Soldering Copper Cables to Copper Pins Objective: The objective of this induction heating application is to solder cables to copper pins for harness manufacturing. The customer is a manufacturer of mission-critical test systems for the Aerospace Industry. The goal is to reduce soldering time from 10 minutes by hand to less than 1 minute … Read more
Objective To simultaneously high frequency Induction Soldering Brass Tubessolder to a brass water jacket assembly with induction heating. Equipment DW-HF-15KW Induction Heating Machine Key Parameters Power: 5 kW Temperature: 424°F (217°C) Time: 10 seconds until the alloy flows; 15 seconds to allow alloy to even out around the tube. TEST 1 Materials • Brass water … Read more
Objective Induction Soldering coaxial cable to connector ring and pin in two steps in under 5 seconds by reaching a temperature of 500°F (260°C) with induction heating. Equipment DW-UHF-6KW-III handheld induction heater Channel coil Materials • No-flux solder wire • Coaxial cable • Cable connector • Center pin Key Parameters Power: 3.0kW Temperature: 662°F (350°C) … Read more
Objective: Test –Induction Soldering Copper Pipes to PCB Board Industry: Medical & Dental Materials: Flat copper pipes, PCB board Alloy: Low-temperature solder paste Equipment: DW-UHF-6KW-I Handheld Induction Heater Power: 1.88 kW Time: 15 secs. Coil: Coated custom-made coil. The Process: HLQ was contacted by a leading manufacturer of clinical diagnostic equipment who is striving to drive innovation in the Magnetic … Read more
Hig Frequency Induction Soldering Brass Corner Joint Objective Successfully solder two 45° brass corner joints. Equipment: DW-UHF-10kw induction soldering heater Materials StayBrite #8 silver solder supplied by customer Bridgit solder flux supplied by customer Brass corner joint Pancake coil Key Parameters Power: 5.5 kW Temperature: Approximately 550° F (288° C) Time: 20 sec Process: Flux … Read more
High frequency induction soldering copper tubing to brass valves Objective: Test: Induction Soldering copper tubing to brass valves Industry: HVAC Materials: Copper and brass pipes Equipment: DW-HF-25kw induction heating machine Power: 16 kW Temperature: 932oF (500oC) Time: 20 seconds Coil: Coated custom-made coil. The Process: This application request was brought to HLQ Induction Heating Power’s attention by a HVAC company. Their … Read more