Induction Soldering Cable to Metallic Plate

Objective
The purpose of this test is to demonstrate the induction soldering cable to metallic plate process.

Recommended Equipment
The recommended equipment for this test is the DW-UHF-6kw-I handheld induction heater.

Key Parameters
Power: Up to 0.72 kW
Temperature: 482°F (250°C)
Time: 4.5 seconds to 14 seconds

Results and Conclusions:

The results were satisfactory at 14 seconds. The complete process can be achieved in less than 5 seconds by increasing the frequency from under 200 kHz to over 300 kHz, as well as by increasing the induction heating power