induction Preheating aluminum flanges
Description
induction Preheating aluminum flanges
Objective: Induction Heating aluminum assembly for a preheat application.
Material : Aluminum flanges (2.35ā by 4.83ā / 60 mm by 133 mm) and (3.35ā by 6.91 / 85 mm by 176 mm)
Aluminum tubes (.63ā / 16 mm OD) and (.92ā / 23mm OD)
Temperature: 600ĀŗF / 315ĀŗC
Frequency: 150 kHz
Induction Heating Equipment
-DW-UHF-20kW induction heating system, equipped with a remote workhead containing two 1.5Ī¼F capacitors for a total of .75 Ī¼F
– An induction heating coil designed and developed specifically for this application.
Induction Heating Process:
A helical coil is used around the smaller parts, which are held in a vise while the flange is inserted into the coil. The small parts are heated in 20 seconds and reach the desired temperature at the joint area.
A larger helical coil is made to heat a larger aluminum assembly, which requires the same desired temperature. The
coil heats the larger assembly with the same power supply configuration, but requires more energy. This assembly is
heated for 20 seconds and reaches the desired temperature.
Narrative
Two helical coils are positioned under the outer rim of each part. This will be needed to soak heat into the interior of the two parts.
Results/Benefits Induction heating provides:
-Higher quality end product vs. using an open flame convection furnace. Ovens are sensitive to ambient temperature and humidity variations and tend to produce uneven results
– Even distribution of heating
– Quick, clean precision heat for fast cycle times
