Brazing Cutting Tool with Induction

Brazing Cutting Tools with Induction

Objective: To braze cone and shaft for a cutting tool

Material Customer supplied parts

Temperature indicating paint Braze preforms

Temperature 1300 – 1400 ºF (704 – 760 °C)

Frequency 400 kHz

Equipment: DW-UHF-6kw-I, 250-600 kHz induction heating system, including remote heat station using two 0.66 μF capacitors (total 1.32 μF) A two-position, two-turn induction heating coil designed and developed specifically for this application.

Process: Two sets of parts are placed in the individual coils. Braze preforms are placed on the cone at the joint. The assembled part is placed inside the induction heating coil and heated until the braze melts.

Results/Benefits: efficient coil design enables simultaneous heating of two parts on the single 2kW system. dual braze is accomplished within required process time, increasing process throughput

Please enable JavaScript in your browser to complete this form.