Induction Soldering Electrical Circuits Board With High Frequency IGBT Soldering Heater
Objective To heat multiple joints on flex circuit strips to 180-200Ā°F withinĀ seven seconds for a soldering application.
Material Copper bonded to polyester flex circuit strips, Solder PlusĀ Paste 63NC-A, 0.0625ā thick Teflon sheets
Temperature 183Ā°F
Frequency 278 kHz
Equipment DW-UHF-4.5kW power supply, remote heat station with oneĀ 1.2 Ī¼F capacitor and a specially designed induction coil.
Process A specially designed induction coil was used to provide evenĀ heat in the area where the fingers of the flex circuits overlap.Ā Initial tests were done to establish a heating pattern andĀ determine time-to-temperature. After a very light coat of theĀ solder paste was applied to the circuit connections, a small
amount of pressure was applied to the Teflon sheets to holdĀ the circuits together. RF power was then applied for 6.5Ā seconds to flow the solder paste and bond the flex circuits
Results Consistent and repeatable results were achieved using theĀ DW-UHF-4.5kW power supply in 6.5 seconds at 183Ā°F.
