Induction Soldering Stainless Steel Tubes to Brass Base

Objective
Induction Soldering stainless steel tubes to brass base

Equipment
DW-UHF-6KW-III handheld induction heater

Materials
Customer material
including flux

Key Parameters
Power: 2 kW
Temperature: 482°F (250°C not measured)
Time: 14 -16 sec

Process Steps

Customer process instruction has been followed
DW-UHF-6KW-III induction heating system was limited to 2kW

Results and Conclusions

Sample position according to the coil is vital.Induction Soldering Stainless steel is heated much fasted than the brass. So, the coil is positioned over the brass part (around 95%)